Anyone have a suggestion.....I recently started my 03 650 and let it warm up. It has been extremely tough to start when cold. Well I forgot to turn the fuel on and it drained the bowl dry. Sure enough the float was stuck down when I turned the fuel on and proceeded to run out the tube at the bottom of the bowl.
I decided the pull the carb off, cleaned the bowl, jets and float. I also replaced the primer. My issue now is that it doesn't seem to be getting gas. It fires up after I prime it, but once it burns the small amount of fuel that the pruser pumps in, it shuts off.
These bikes are gravity fed right? No pumps to go bad? I'm still searching for a filter.
Thanks in advance for any help!
I decided the pull the carb off, cleaned the bowl, jets and float. I also replaced the primer. My issue now is that it doesn't seem to be getting gas. It fires up after I prime it, but once it burns the small amount of fuel that the pruser pumps in, it shuts off.
These bikes are gravity fed right? No pumps to go bad? I'm still searching for a filter.
Thanks in advance for any help!