wildrinny

i have a 2007 rincon, it just dies while riding. i determined there was no spark. i started trouble shooting ohmed the coil, wire, and pulse generator, all were good but pulse generator. it ohmed o/l. so i replaced the stator/pulse generator assembly. put it all back together and still no spark. im clueless all fuses are good. what to do next. im ready to set it on fire?!

Brandon2011Rincon

Have you put a screw driver into the plug wire boot and tried starting it to see if there is spark arcing from the screw driver to a metal frame member on the bike. That would at least tell you if the plug is the problem or if the problem is the other direction. (an old snowmobile trick I learned)

bradillac

Possible that your kill switch on your handle bar has gotten wet, or malfunctioning for any reason? That would kill your fire.

__________________
03 rincon. 2" lift. 27" 589's. 3000# wench. Relocated. Radiator. Homemade dual snorkel. Dynatec cdi. Clipped carb spring. Rejetted carb. Hmf utility exhaust. K&N filter. Mudbuster camshaft by hotcams.

Mudbuddy

get a manual and follow the trouble shooting diagnostics flow chart step by step to find the problem. Avoid the desire to jump steps and throw parts at it.

__________________
2006 camo Rincon, Kimpex trunk, 2.5 Warn winch, Mudbuddy ThumbBuddy, Warn front bumper, Atv-Guru rear bumper and combo hitch kit, High Lifter springs, VTR Spring Spacers, Garmin gps, Stewert Warner Temp and Volt Gauges, Swisher heated grips, ITP Terra Cross rt's, full AP skid plate setup ~~~~~~~~~~~ 2007 Foreman with power steering and ES for the wife, Maxiss Bighorn radials Warn RT2500 winch, Mudbuddy ThumbBuddy, Aluminum Products Hitch Holster, Skid Plate and Stick Stoppers and a custom built rear bumper, Moose heated grips and thumb warmer, Cycle Country plow, Rotopax fuel pack.