07 rincon 680 - Honda Rincon Forum : RinconRiders Honda Rincon Forums
Reply
 
LinkBack Thread Tools
post #1 of 11 (permalink) Old 08-13-2015, 01:01 PM Thread Starter
Junior Member
 
Join Date: Aug 2015
Location: FT.POLK, LA.
Posts: 1
07 rincon 680

Bought bike would go in gear & run fine ,park up 15-20 min would go in gear but not go anywhere , replaced oil pump & chain , now wont move at all ,but will jump when put in gear f & r checked oil pressure none , replaced with new oil pump still no pressure at test ports, new o rings both times and checked pressure releif valve , swaped solinoid setup from another rincon still nothing
HANDYMANDAN is offline  
Sponsored Links
Advertisement
 
post #2 of 11 (permalink) Old 08-17-2015, 02:06 PM
Senior Member
 
YellowCJ's Avatar
 
Join Date: Aug 2004
Location: Maine
Posts: 2,281
make sure your using correct oil and make sure its filled to the correct level for starters. Then check the linkage for the shifter.

Impeach The US Government!
Why, because it no longer stands for Americans!

Government is not the answer to our problems, government is the problem!

Taxation is the antithesis of freedom.

2004 Yellow Honda Rincon with Warn 2500 winch, Moose cargo rack, Moose gun rack, Moose 60" Snow Plow, Honda trailer hitch, Yuasa YTX 20-BS Battery.
2006 Jeep Grand Cherokee Limited-5.7L V8 HEMI, Tilt utility trailer with Fastrap Tiedowns.
2007 Honda Shadow Aero 750, 2010 Massey Ferguson GC2410.
YellowCJ is offline  
post #3 of 11 (permalink) Old 08-17-2015, 03:26 PM
Member
 
Joe maran's Avatar
 
Join Date: Feb 2012
Posts: 1,075
X-2 with what yellowcj said. Do not screw in dip-stick. Fill just above full mark. Use oil for wet cluch use. When checking pressure , 3 ports on left side of engine for 1st,2st and 3rd gear clutch. On right side of engine 1main port. 114 PSI at 5000 RPMs.

2007 rincon W/GPScape. 3000 Warn winch W/rope on front,4000 Warn winch W/cable on rear and wireless remote,custom winch switches, BIG GUN exhust and fuel control,RD lift,Garmin GPS,full custom skids W/bush guard,12 SS chrome W/28 -10s Gorilla on all 4 corners,custom 1 1/4 in reciever W/tow hook,BRGR gears,K/N filter,2 in snorkel.

2007 Rincon camo, 12in ITP rims (black), 26in mudlites ,the rest stock for now.
Joe maran is offline  
 
post #4 of 11 (permalink) Old 08-20-2015, 11:22 PM
Member
 
jwernatl's Avatar
 
Join Date: Feb 2015
Posts: 33
LEVEL CHECK NOTE: • Check the oil level after starting the engine and allowing the oil 10 circulate through the engintl thoroughly. It is especially important on a dry sump engine, due to the comparatively large vol ume of oil, • Do not snap the throttle while idling or the oil level reading will be inaccurate Place the vehicle on level ground. Start the engine and let it idle for 3 - 5 minutes. If the air temperature is below to C {50 Fl. let the enqine idle for an additional 5 minutes (a total of to minutes). Stop the engine, wait for 2 - 3 minutes, and remove the dipstick and wipe it clean. Check the oil level by inserting the dipstick into the engine without screwing it in.

Genesis 1:1 In the beginning God created the heavens and the earth.
jwernatl is offline  
post #5 of 11 (permalink) Old 08-20-2015, 11:23 PM
Member
 
jwernatl's Avatar
 
Join Date: Feb 2015
Posts: 33
RECOMMENDED ENGINE Oil: Pro Honda GN4 or HP4lwithout molybdenum additivesl 4·stroke oil (U.S.A. and Canada). or Hond a 4-strokeoillCanada on ly),or an equivalent m otorcycle oil API service classification: SG or higher [except oils labeled as energy conserving on the circular API service label] JASO T 903 standard: MA Viscosity; SAE 10W·40. 5W-3

Genesis 1:1 In the beginning God created the heavens and the earth.
jwernatl is offline  
post #6 of 11 (permalink) Old 08-20-2015, 11:31 PM
Member
 
jwernatl's Avatar
 
Join Date: Feb 2015
Posts: 33
OIL PRESSURE CHECK Start the engine and check the oil pressure. OIL PRESSURE (80'C/176'F): 785 kPa (114 psi) at 5,000 rpm (min" ) Check the oil level and add the recommended oil if necessary (page 4-10). Also, warm the engine to normal operating temperature and check for external leaks. Remove the oil gallery sealing bolt and washer on the left side of the front crankcase cover. NOTE • Clean around the sealing bolt with compressed air before removing the bole, and be sure that no dirt enters the oil gallery. Connect an oil pressure gauge and adapter to the oil gallery hole. Stop the engine and remove the oil pressure gauge and hose. Install the sealing bolt with a new sealing washer and tighten the bolt securely. STart the engine and make sure there are no oil leaks.

Genesis 1:1 In the beginning God created the heavens and the earth.
jwernatl is offline  
post #7 of 11 (permalink) Old 08-21-2015, 10:24 AM
Senior Member
 
Harley Dog's Avatar
 
Join Date: Mar 2006
Location: Carson City, NV
Posts: 5,722
I went to Synthetic Oil at my first oil change. It is in my opinion a better oil to use than conventional oil. It is slippery and protects things like the cam better. Again just my opinion.

2005 Green Rincon, Dynotek Ignition, Dynotek HP Coil, HMF Utility Exhaust, K&N Air Filter with Outerwear, DynoJet Spring and Needle, Keihin Jets 162 Main, 52 Pilot ,TPI Valves, 2500 Super Winch, Warn Front Bumper, ATV-GURU Rear Bumper, HighLifter Front Springs, A\P Belly Plate\w front and rear Stick Gaurds, ITP Wheels, Bighorn 25 inch Tires, AIPP Headlight Bulbs, Temp Gauge, Modified A\F Screw, Tiny Tach, Rear Hitch, ATV Guru Front Tow Hook, Stainless Steel 17-4 Tie Rods
Harley Dog is offline  
post #8 of 11 (permalink) Old 08-21-2015, 04:07 PM
Member
 
Joe maran's Avatar
 
Join Date: Feb 2012
Posts: 1,075
Hey Harley dog, I was under the impression that straight synthetic oil would have a negative effect on the Rincons clutches, too slippery.

2007 rincon W/GPScape. 3000 Warn winch W/rope on front,4000 Warn winch W/cable on rear and wireless remote,custom winch switches, BIG GUN exhust and fuel control,RD lift,Garmin GPS,full custom skids W/bush guard,12 SS chrome W/28 -10s Gorilla on all 4 corners,custom 1 1/4 in reciever W/tow hook,BRGR gears,K/N filter,2 in snorkel.

2007 Rincon camo, 12in ITP rims (black), 26in mudlites ,the rest stock for now.
Joe maran is offline  
post #9 of 11 (permalink) Old 08-21-2015, 04:24 PM
Senior Member
 
Harley Dog's Avatar
 
Join Date: Mar 2006
Location: Carson City, NV
Posts: 5,722
I use Mobil 1 Racing 4T 10W-40. It has a JASO MA rating which is just fine for the Rincon and all other ATV and Motorcycles with a wet clutch.

2005 Green Rincon, Dynotek Ignition, Dynotek HP Coil, HMF Utility Exhaust, K&N Air Filter with Outerwear, DynoJet Spring and Needle, Keihin Jets 162 Main, 52 Pilot ,TPI Valves, 2500 Super Winch, Warn Front Bumper, ATV-GURU Rear Bumper, HighLifter Front Springs, A\P Belly Plate\w front and rear Stick Gaurds, ITP Wheels, Bighorn 25 inch Tires, AIPP Headlight Bulbs, Temp Gauge, Modified A\F Screw, Tiny Tach, Rear Hitch, ATV Guru Front Tow Hook, Stainless Steel 17-4 Tie Rods
Harley Dog is offline  
post #10 of 11 (permalink) Old 08-21-2015, 05:48 PM
Member
 
Joe maran's Avatar
 
Join Date: Feb 2012
Posts: 1,075
Never doubted for a second that you done your homework before you decided to use it. I used synthetic in my differentials and glad you pointed that out to me for the engine. thanks.

2007 rincon W/GPScape. 3000 Warn winch W/rope on front,4000 Warn winch W/cable on rear and wireless remote,custom winch switches, BIG GUN exhust and fuel control,RD lift,Garmin GPS,full custom skids W/bush guard,12 SS chrome W/28 -10s Gorilla on all 4 corners,custom 1 1/4 in reciever W/tow hook,BRGR gears,K/N filter,2 in snorkel.

2007 Rincon camo, 12in ITP rims (black), 26in mudlites ,the rest stock for now.
Joe maran is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Honda Rincon Forum : RinconRiders Honda Rincon Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome