Hello all, I just picked up a 2005 Rincon project. It did not run and the display is inop. I cleaned the carb, charged the battery, and she cranked over. It runs but it is rough. The issue is that there was a wire that runs from the bottom of the carb that was not attached. I found where it should be connected and the beast smoothed out but when I gave it throttle the ignition fuse blew. Rinse and repeat. Disconnect the wire and no electrical issue but it starts running rough. I traced the wiring and saw no obvious signs of frayed wires.
Any hints? Is it because the display doesn't work? Any help would be veeerrrry appreciated.
Chris
Any hints? Is it because the display doesn't work? Any help would be veeerrrry appreciated.
Chris
