Honda Rincon Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have an 03 Rincon 650 with a rebuilt carb I put in it and I have messed with the pilot screw turning it out a little bit than throttling it but it does rev up it will rev and sit at a low rpm even when pushing the throttle at the carb. Does the rpm have to be set at 1400 to adjust? Or could there be something more wrong.
 

·
Super Moderator
Joined
·
6,718 Posts
I posted how to on your original thread. You say the problem was not there b4 you messed with the carb, so go back and find what you did wrong. The service manual pages were also posted so you can do the proper initial adjustments. Unless your magic, and can count fast, yes a tach is required to set the idle.
 
1 - 2 of 2 Posts
Top