Honda Rincon Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
This post is info for others in the future that choose a ramsey wireless winch.

I could'nt figure out where to put the reciever and the solenoid. After looking at the whole project for about a week a neat solution came to mind. I mounted the receiver inside the glove box up high in the back and ran the wires out the front. I mounted the solenoid on the other side on the outside of the glove box. The electrical studs are just above the top of the glove box. That installation will cut down on wire run to the back of the bike. I also bought a warn mini rocker switch to use with the ramsey. I will then tape the antenna to the inside of the right tank cover plastic. Came out great.

If I could figure out how to post pics I would.
 
1 - 3 of 3 Posts
Top