Honda Rincon Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
Hi gang! I just received my DynoJet kit in the mail. Here's a couple questions: If I put the DynoJet kit in, using the stock filter, would I have to re-jet or go through all that carburator stuff all over again once I put a K&N filter on it? Or, should I just wait and put it on all at once? Can anyone tell me where I can get a K&N filter/pre-filter for the best price?

I don't mind telling you all that this is one of the best forums I have had the chance to get on. Even though you don't all agree on every factor, you all have some very good advice. Thanks!!
 

·
Registered
Joined
·
314 Posts
Put it on NOW! Follow the instructions for jet size, most use the #144 without other mods. The filter will not make much difference, and should not effect the jet choice. UNI makes a highly regarded filter available at rockymountainatv.com under "intake".
Greg
 

·
Registered
Joined
·
50 Posts
I would wait for the filter. You will have to re-jet when you add a high flow filter to get the maximum performance. If you don't mind doing the jetting, go for it.
 

·
Registered
Joined
·
409 Posts
Rockymountainatv.com has the K&N for $39.99, and outerware for $9.99. Jet kit is $44.99.
 

·
Registered
Joined
·
42 Posts
Discussion Starter #5
Thanks Duramax, I'll order tomorrow!!
 

·
Registered
Joined
·
282 Posts
Karl I just ordered the Jet kit, outerwears, and K&N air filter from rockymountainatv.com they seem to have the best prices on the net! They shipped the stuff the morning (early morning) after I ordered (i ordered at 8:00PM). So they have quick service. I am crossing my fingers that it will be here friday so saturday me and 03rincon can install it!
 

·
Registered
Joined
·
42 Posts
Discussion Starter #7
Thanks Jason...I'll be contacting them soon!!!
 
1 - 7 of 7 Posts
Top