[fieldm]

Does anyone have this? and also do you recommend it?

http://www.highlifter.com/store/650fenkt.html

The other week I put a hole in the front bumper, (plastic part) where a support rod was. Now I have to replace the entire front of my quad. I would like to prevent this from happening again.

 

[WOOD]

The Fender Kit just relocates the brackets to allow you to run bigger tires.

 

[SXflyer]

lift the quad straight up on the rear bumper ( turn fuel off first), Then disconnect the brace and remove it. Bend it a few degrees more and replace it and bolt it back up to the other brace. It will line up a little farther down the frame tube and you can clamp it to the tube with a stainless steel clamp. I have been running 28' ITP 589's this way with no problems and it holds there just fine. Takes about ten minutes. Cost- 2 bucks

 

[marine]

have you noticed any performance decrease from running 28" 589's?? I had 27" titan 589's on my rubicon and noticed performance loss (accelaration, and top end speed).

 

[SXflyer]

Jason,
Can't have your cake and eat it too. The top end went from 64 down to about 57. Not sure about acceleration as I don't really wheelie or 1/4 mile it. Just use it primarily for off road and mudding. The tires cannot be beat.
Bill