Honda Rincon Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
(The Drive selector) I throw the shifter into reverse no problem. But when I throw it in Drive it Clatters. I adjusted the Shifing linkage and still clatters in Drive. Idle is low, its not the problem. O-ring, TPS, could these be a problem.
 

·
Registered
Joined
·
121 Posts
When you say that you had adjusted the linkage. Where did you do your adjustment, down low behind the engine, close to the oil fill tube.
Or did you adjust the linkage under the gas tank???
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #3 ·
I adjusted the linkage under the gas tank. No matter were I put the lock nut its the same.
 

·
Registered
Joined
·
121 Posts
Did you do the adjustment, the way that the service manual says to do it.
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #5 ·
yes. loosen nuts fully, shift to drive then reverse and back to neutral. Tighten one nut and then the other.
 
1 - 5 of 5 Posts
Top