[650ccMatt]

Hey dudes, im looking for some suggestions. I am only doing these "mods" for any kind of water or mud riding i will do. So far i have rerouted my 2 carb vent lines to the display pod area and put dielectric grease on my Sparkplug and winch connections. Do you guys have any other suggestion.

Thanks

Matt

 

[vze2wxxe]

Matt put dielectric grease on your coil connections especially the little slip on clip on the coil and then run a small 2" diameter snorkle up to your gas tank. This will stop sputtering problems.Cut off the square box at the end of your stock snorkle,attach a 2"90 degree rubber plumbing hose to the new cut off end than cut a hole through the plastic body work above your stock snorkle than slide an another 2" 90 degree solid plumbing into the rubber one and point it towards your gas cap. This works wonders and gives the Rincon about one foot more water fording ability.No jetting changes are required. Take care Steve.

 

[650ccMatt]

Stevo,

Should i make an extension for the exhaust pipe too, so that is not underneath the water? Should that even make a difference. Thanks for the help.

Matt

 

[vze2wxxe]

Matt No you don't need tail pipe extension. As long as you stay on the gas the exhaust pressure will keep water out of your pipe.If you intend on camping out in the water idling than I would extend the tail pipe.Remember grease your coil wires, if you don't the minute your coil gets wet you will stall out. Steve

 

[650ccMatt]

Well i greased up all my electrical today, including the coil. I also rerouted that vent line that came off of the waterpump, good idea? Thanks for the help steveo.

Matt