Honda Rincon Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I just ordered the Power Tech 4 yesterday should be here Thur and going to put it on this weekend. I was wandering what all is there needed to remove or tricks in removing the stock muffler and putting the Power Tech 4 on. Bascially what is the easiest way in installing this. Any imput on this I would truely appreicate it. By the way was there much power gain with this with the KN, Dial-A-Jet, and pipe set up, if so where were the gaines.

Thanks
 

·
Registered
Joined
·
24 Posts
If you intend to keep/save your stock muffler, then you will have to take the entire rear of the quad off (rack, plastic, lights, etc.). There is not enough clearance to get the whole assembly out unless you move something. I just took the Sawzall and cut the pipe to get mine out and chunked it in the trash.
 

·
Registered
Joined
·
201 Posts
I saved mine and had to remove the entire rear end. Not much for tricks to getting it off, just follow the steps in the shop manual and you will be fine. A bit long winded process, but well worth it.
 
1 - 3 of 3 Posts
Top