Honda Rincon Forum banner

Made an Air Screw Adjustment

1113 Views 6 Replies 3 Participants Last post by  sparky
Took the carb loose an turned the carb over enough to get to the adj. screw. It was set at 2 1/4 turns out. Increased it to 2 3/4 and can not tell any difference.
1 - 7 of 7 Posts
Buy an airfilter and DynoJet kit and you will really like the difference.
If you are stock then about 2 & 1/2 is good....
While still stock, would it help eliminate the bog if I moved the needle up?

Not ready for a pipe, filter and jets.
if you dont have the dyno jet kit, then the only way to move the needle up is to put another small spacer under it....I dont think youll see a gain with a stock machine.

Thats another advantage of the DJ kit, the needle has clip adjustments which makes fine tuning easier....

And, the DJ spring is smaller adding to throttle responce.
Wher did you get the DJ Kit?
HL'r has them, but I got mine at a local atv/snowmobile parts place.
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.