Honda Rincon Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Should I place the washer on the oil pump side of the sprocket or bolt side?

my sprocket has sideway movement and I fabricated a washer to take up the space. It made a huge difference in firming up the slack.

Please do not discuss purchasing a new oil pump, or sprocket, or shaft. I can start another thread if someone wants to debate that topic.



image.jpg
 

·
Registered
Joined
·
9 Posts
Discussion Starter #2
The shim is approximately 1mm thick and the ID is 11mm.

it is a bit more work, but I could replace this one with two .5mm think ones and place them on either side of the sprocket to center it.

however, I assume that the sprocket on a néw pump would be flush against the body of the pump; that is why I chose to place the amwasher in the outside of the sprocket.
 
1 - 2 of 2 Posts
Top