Honda Rincon Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Recently cleaned and rebuilt the carburetor on my 2003 Rincon. Also replaced the coil and spark plug boot due to damage from the last shop repairs. After reassembly, I have a good idle and rev response when in nuetral, but I do not have the shifting or power response when going up an incline grade. The unit had plenty of power prior to the rebuild, but would not idle down and needed to run with the choke out. Any ideas would be helpful.

Thank you.
 

·
Premium Member
Joined
·
8,084 Posts
It would be quite a coincidence, since you didn't mess with anything internal, but it sounds like the oil pump O-rings might have failed. There is plenty of info here about the issue and repair.
 

·
Registered
Joined
·
431 Posts
I would start with the basics... correct oil used? JASO-MA approved? Correct level?

Sent from my SM-N960U using Tapatalk
 
1 - 4 of 4 Posts
Top