Honda Rincon Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
226 Posts
Discussion Starter · #1 ·
Hy Guys!
Sorry about the first post,this weekend I changed a boot on my rincon on the rear right,usually those type of drive shaft are not hard to remove.So I when ahead and proceed to remove it with a pry bar while pulling on it,I could not remove it I even tried with a puller and was not able to take it off.Did this situation already happen to you guys and how did you took it off without damaging anything.I suspect that the small snap ring at the end of the shaft must be caught between the shaft and the gear in the diff.Thank's for the help in advance.
 

·
Registered
Joined
·
226 Posts
Discussion Starter · #2 ·
Hi Guys!
I can't believe I'm the only in north america who had that problem,let me now if you had that same problem.Waiting for a reply.
 
1 - 2 of 2 Posts
Top