As anyone snorkle their bike, and if so how did you route the plumbing. I don't want to go in real deep water but I think it would help with the steaming issue. I have already rerouted the carb vent lines.
I used 2" vac hose, came out of the airbox at the rubber connector, ran it around the right side of the motor over the starter, under the gas tank and up under the cover beneath the pod. It's protected from debris/water by the cover and can go in water to the top of the tank. Ran the vents with it. Nice thing is no cutting plastic and you can't tell its there.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.