[clown]

I just cleaned and reinstalled my carb and now the bike cuts off after a wot run could i have gotten the sensor out of adjustment and thats what is causing this i just eyeballed it putting it back on cant figure out why its running so bad now was running fine before just had some trash under the needle and seat any ideas would be appreciated ???

 

[Oilcan]

follow the TPS setting adjustment in the manual. You need a baseline setting which you farked up when you took it apart. should be fine after that.

 

[Grumpy2]

YES! it's out of adjustment. You need a shop manual for the '03 -'05 If you don't have one you may have to take it to a Honda dealer to get it reset.

 

[Oilcan]

A = yellow /black, B = green / yellow , These are the terminal wire colors , disconnect them and adjust the TPS so you get 490 -510 Ohms. Tighten and reattach the terminal..... (only if you undid the 2 torx screws holding the TPS sensor) If you did not do that, then you have to make an initial setting for the TPS.

PM me an e-mail and I will send you the word doc... to big to attach here....

 

[Oilcan]

http://dl.dropbox.com/u/44256836/TPS Initial adjustment.doc

This is the "How To' for initial setting of TPS Sensor, after you make sure your resistance is as stated above.

 

[clown]

let make sure i got this right i set the resistance first and then do the button pushing OR i do the button pushing first ??

 

[Oilcan]

You PM'd me that you removed the TPS to clean it.... not a good thing to do but totally recoverable. (loosened the 2 torx screws), so you have to set both conditions. Resistance, then buttons.

 

[clown]

OK got it thanks for your help

 

[mario.loguisto69]

A = yellow /black, B = green / yellow , These are the terminal wire colors , disconnect them and adjust the TPS so you get 490 -510 Ohms. Tighten and reattach the terminal..... (only if you undid the 2 torx screws holding the TPS sensor) If you did not do that, then you have to make an initial setting for the TPS. PM me an e-mail and I will send you the word doc... to big to attach here....

Is there some kind of video on how to adjust a TPS senser having issues