Joined
·
122 Posts
Hey when my Honda is down shifting if you give it a little gas or pat the gas it makes a whining noise but it might be grinding a little. It shifts smoothly and everthing Idk whats going on.
transmission or rear end trouble I guess help plz
1 - 12 of 12 Posts
2011 Honda Rincon. 2” Lift, RDC Rad relo, Highlifter springs, 14” STI’s with 27x10-14 Wildthang’s
Joined
·
779 Posts
Check your diff fluid level to start.
Joined
·
122 Posts
I have completely changed all fluids no help. Someone told it could be the bearing in the main shaft or one of the gears could have a broke or chip tooth.
Joined
·
314 Posts
If your talking the bearing that is pressed into the case for the output shaft, almost always it will wipe out the seal and start leaking oil when the bearing is bad.
To check the gears you should be able to jack up the machine to get the tires off the ground, pull the fill plug on the diff, and slowly spin the wheels and look for any damage on the ring gear.
To check the gears you should be able to jack up the machine to get the tires off the ground, pull the fill plug on the diff, and slowly spin the wheels and look for any damage on the ring gear.
Joined
·
122 Posts
Could it possible be something in the transmission whining. I looked up and for all parts in the transmission for a rebuild would cost me $650.
Joined
·
122 Posts
Another thing i am wondering when i bought it the guy didnt know anything about the rincon. What kinda after market parts. I was just wondering if it don't have a BRGR like i think it does and pulling them tires are messing something up. Or could it be the whole final drive gear is going out IDK plz help someone.
Joined
·
122 Posts
Okay plz help with this I checked the oil level fine. I rode it yesterday and the whining nosie when you let off the gas and push it softly it sounds like its coming from the back of the motor. It also shift in different gears steady like it can't find the right gear.
Joined
·
122 Posts
Could it possible be something wrong with the rear diff because i hear it sounds like it coming from the rear.
Joined
·
6,972 Posts
Start with the BRGR, it is after all a gear reduction on the final drive. (Where you say the noise is coming from) Open the case and either inspect and repair, or remove the BRGR. The whining is most likely gear noise. Who knows what has been done in there, if the previous owner did a proper job on the installation of the BRGR.... until you actually touch some parts and attempt to locate the noise, by jacking the quad up, and running it safely on stands or cement blocks, we all can guess and guess, till the cows come home.
Joined
·
8,169 Posts
The rincon has a computer program that controls shifting in the TCU (tranny control unit). It monitors throttle plate angle, sped of throttle application, atv speed, brakes, and other stuff. You may be confusing the TCU into shifting too soon. That is if you are using the auto mode.
Mine whines if I manually shift it to a lower gear than it needs.
Mine whines if I manually shift it to a lower gear than it needs.
Joined
·
122 Posts
Idk what that is but is it normal or do i need to fix something it does it in auto worst than in manual.
Joined
·
1 Posts
I have an 03 rincon 650 that goes in gear but wont move when going into drive or reverse there is a grinding noise and a little lurch forward but nothing else any ideas what it could be
1 - 12 of 12 Posts
